|
|
Machine
Shop 4 |
|
|
Machine
Shop 4 |
Advanced Inspection
- Sine Bar
Please turn into instructor after completing
required operations
| Part # 2B
Part Description: Advanced Inspection - Sine Bar Quantity Req.: 1 |
Name _________________________
Date: ________________ |
PLEASE HAVE INSTRUCTOR INITIAL AND DATE GREY BOXES (*), AFTER REQUIRED OPERATIONS
| Step# | Location | Description | Initials | Date |
| 10 | Inspection Area | Have an instructor assign an angular part to be measured. | ||
| 20 | Inspection Area | Use the CMM or bevel protractor to measure the angle. Record the measurement. | ||
| 30 | Inspection Area | Using the sine formula discussed in the text, determine the Five inch sine bar elevation. Record your calculations. | ||
| 40 | Inspection Area | Calculate the gage block stack up. Make sure you are using wear blocks. | ||
| 50 | Inspection Area | Select the blocks. Clean the blocks. Wring the blocks together. | ||
| 60 | Inspection Area | Set up the Sine Bar on the surface plate. | ||
| 70 | Inspection Area | Check the workpiece using the dial indicator as discussed in the text. | ||
| 80 | Inspection Area | Adjust the sine bar elevation until the dial indicator reads 0.001 TIR. | ||
| 90 | Inspection Area | Using the Machinery’s Handbook, look up the table of sine bar constants and determine the actual angle of the part based on the gage block stack up. | ||
| 100 | Inspection Area | Record your answer. | ||
| 110 | Inspection Area | Have instructor check set up. | * | |
