Machine Shop Home  
  Introduction  |   Shop Safety  |   Layout  |   Inspection  |   Bench  |   Cutting Fluids  |   Sawing  |  Drilling

Drilling Machines - Project G2 - Operations
Drilling Home

Part # G2#2

Part Description: Operation of Controls on a Radial Drill

Name _______________________ Date: _____________

PLEASE HAVE YOUR INSTRUCTOR INITIAL AND DATE THE GREY BOXES (*) AFTER THE REQUIRED OPERATIONS.


Demonstrate to an instructor the following steps on the radial drill(s):
Have each step checked (X).

Description  Initials  Complete
Where it should be lubricated *  
Raise and lower arm. *  
Pivot arm. *  
Move head in and out. *  
Move spindle up and down by hand. *  
Move spindle up and down by hand using the speed reducer (fine feed). *  
Start and stop machine. *  
Set RPM. *  
Set feed. *  
Run spindle forward and in reverse. *  
Power feed spindle. *  
Install and remove tool(s) in spindle. *  

____________________________ Instructor Signature   ______________ Date